I remixed my remix (This Original is Ductippi's CB09 adapter) again because the first version was a bit too small for me when I changed the tools and I wanted to have a surface on which I could mark so as not to mix up the knives. Then this version came out.
The dimensions are taken from my CB09 (unfortunately the Chinese don't always take the dimensions of the cheap parts that precisely - so there is no guarantee that yours will also fit) **The parts are very tight (no desire for tape and wobbling.
So a resin print is recommended and the CB09 needs to be pressed into the parts a bit.
For FDM printers, the note at the bottom may help...**
You can use the metal plate from the white adapter that comes with the Cameo 4 so that it is recognized automatically – I think a 14x7x0.5 mm aluminum sheet should also do the trick, but since I don't need the adapter I used the sheet from that.
Please note that these are not original Silhouette accessories, so using them can invalidate the guarantee. Use is at your own risk.
Since well-adjusted FDM printers also have the property of printing the inside diameter a little too small, this setting may help to compensate for this. Unfortunately, we don't have much space for tolerances here and the CB09 should fit as precisely as possible in the adapter.
The author remixed this model. Imported from Thingiverse.
Erhöhte Bauform zum besseren Greifen mit Beschriftung zum Winkel der Klinge und Skala