Bins for Stanley Storage Container-UPDATED

I wanted to reduce the number of places and containers where I had the vitamins (hardware) for 3D printing stored to make it easier to find what I needed. When I printed the small container from Assorted bins for the Stanley organizer case by mgx, it would not work with the Stanley Organizer I purchased from Home Depot.  It was too tall and the lid would not close.  Since I had to redesign the containers, I decided to print them in vase mode.   Since doing vase mode, I decided to go with a 0.8mm nozzle for added strength, and to speed things up because there were going to be a lot of containers to print.  I decided to color coordinate by size (i.e. M3=Yellow, M4=Blue, etc.)  I have included my FreeCAD file so you can modify or add containers.  Although I printed with a 0.8mm nozzle, a 0.4mm nozzle should work just fine.

Since I could not in vase mode duplicate the little feet on the Stanley containers that keep the containers spaced properly, I'm thinking of designing a grid to go in the bottom of the case for that purpose.

I have redesigned the bins again to better fit the grid.