Braces designed to hold a patio umbrella against the railing of a deck. I designed it with the Ikea Fliso umbrella in mind, but it can handle any diameter up to 38mm (and pretty much any size below there, thanks to the screw fastener). The screw holes to fasten to the railing are designed to fit #6 drywall screws.
Printer Brand:
TEVO
Printer:
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
50%
Filament: Hatchbox PLA white
Notes:
The tolerance on the front screw fastener are set to a clearance of 0.4mm, pretty generous, but if you print quickly at low-ish resolution, you'll likely need it. The original version had 0.2mm clearance and required a lot of grinding and finishing post-print to function properly
Category: Outdoor & GardenThe author marked this model as their own original creation. Imported from Thingiverse.