Tiago Jesus

@trajesus

Added brass inserts and cutout for the ESP module on the original "big" case.

26m

1× print file

0.30 mm

0.40 mm

PET

7.00 g

Prusa MK3/S/S+

621

2684

updated February 13, 2024

Printforme

@Audifreak117

Nice Case

Jason Sowder

@JasonSowder_3038650

I used PETG HF Translucent. Perfect print the pin cover even turned out flawless!

Joe

@IamJoe

This case (I only used to top part) is super cool. I like the labels on the buttons which makes it clear what they are used for and makes flushing so much easier. Spacing is on point. Used Prusament PLA orange and vanilla white. Thanks for the model!

Tiago Jesus

@trajesus

Thank you for the rating :)

pfml

@pfml

Printed in PETG, inserts M3x5x4

Many thanks to Tiago Jesus for the design

3DMatic

@natmatic_1890718

What percent of infill works best for this print?

Tiago Jesus

@trajesus

@natmatic_1890718 depends on the amount of top/bottom layers but usually 20% is good enough :)

Printed this before I realised it needed the bread nurls. Not going to use it but it fits well.

Like it

Looks great and offers good protection for the Wi-Fi module. Printed in Overture and Printed Solid PETG.

Tiago Jesus

@trajesus

@nofferman Glad you ike it!

Greg Buxton

@GregBuxton_579550

Printed at 0.16mm on the X1C in Hatchbox True White PLA and Bambu Orange PLA.

Just need to find where I put my brass threaded inserts so I can screw it closed. :)

Greg Buxton

@GregBuxton_579550

Found my inserts, but sadly the only M3 screws I can find on hand are 4mm (too short) and 8mm (too long.)

I guess I'll finish this assembly tomorrow. ;)

Also, please forgive my poor threaded-insert setting. Been a while, rusty. heh. (edited)