Assorted set of mouse gliders, mouse skates or mouse feet

I had a bunch of computer mice that I opened for switch replacement and their old feet (gliders, sliders, skates) were damaged. So, time to use the printer and print new ones !

There are 3 sets of pads here, matching the following brands (possibly other brands too):

• a vertical mouse from CSL, model 300569 (sold on Amazon)
• a Hama model 62807
• a Serioux Baran gaming mouse (this one is the trickiest)

The 2mm ones are a bit thicker and have a fillet, use them if you intend to sand them down a lot (or prefer thicker feet).

The 1mm ones are ready to install directly.

Ideally, these should be printed in nylon (the lowest friction). Printing on a smooth PEI sheet should give you a nice and smooth surface already. Should you wish to polish them some more, I highly recommend getting a set of Micromesh pads which go up to 12000 grit.