Elegoo Neptune 2S LED Bracket (2 Versions)

I couldnt find an LED bracket that i liked for the Elegoo Neptune 2S. So, i made my own.
Designed to clear the printhead at max height, depending on your setup. But my fan sits pretty high on my hotend and clears just fine.

2 separate versions for the brackets. Curved (Bracket 1) is a lower profile that may work with stock fan shrouds. Squared version (Bracket 3) for higher clearance. Light bar works on both versions.

No hardware, friction fit. Bar slides into grooves on the arms and the arms snap onto the top crossbar.
Designed for trimmable LED strip with adhesive backing. LED groove is 7.5mm wide x 3mm deep and is inset inside the light bar.

If you have any questions, feel free to comment.
This was my first design so if you have any suggestions, they would be appreciated as well.

Printed at .2 layer height

15% infill

5 top/bottom layers

4 perimeters 

Polymaker Matte Neon Yellow PLA Filament