Phone Holder for Laptop Universal

Hello, I use Epoccam by Elgato with my Iphone a lot as it is much better than most webcams and a million miles better than the Laptops webcam. This makes a problem of how to position your phone to suit what you want to do.

I created this Universal Phone holder for Laptops.

How it works is, You pop the Version of choice into the slicer of your choice and just adjust the scaling. Measure your phones width and depth(not much of an issue and most will not have to change it) then find the width and adjust it to 1mm less than your phone.

Job Done.

I have printed heaps of these now in both PLA(works great as dead on sizing) and TPU. TPU is the best filament for this and is what I would recommend anyone printing this use.

Please see Print setting for what setting s I used but I have only just started printing with TPU and so maybe you do your research for the best settings to use and if you have ones that work great then please share.

Thank you.

Print Settings

Printer brand:

Creality

Printer:

Ender 3 Pro

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.2 or 0.4

Infill:

30% Triangles

Filament brand:

I used Tronxy (blue) and Sunlu (Black)

Filament color:

What you Like

Filament material:

TPU, TPE, PLA, PETG

Notes:

My printer is and Ender 3 Pro with a 32bit board and a Micro Swiss All metal Hot end and Direct drive.

I printed In both the Tronxy and the Sunlu @ the following settings

Nozzle Temp 235c
Bed Temp 69c (I have a glass print bed, this is to get 62-63c bed surface)
Part Cooling NO
Print Speed 40mms (walls 30mms)
Infill 30% (triangles)
Supports NO
Retraction 1mm (this will be where you have to know your printer)
Retraction Speed 30mms (again you printer so what suits you)
Bed Adhesion Brim 5mm (I printed with both Brim and Skirt but I recommend the
Brim as if it starts to lift this will allow your print to finish
in 97% of the time.)
Z offset 1.35 (again know your printer so do what suits you)
Walls/Top/Bottom 1.2mm (gives good strength and flex)
Quality 0.2 & 0.4 (I like the 0.4 as it is quicker to print and looks good with
a well setup printer.) (I have printed both and had
issues on both but even the Bad ones work and are
used.)

The only other thing I do is adjust the scaling depending on the phone that will be used with it. It is trial and error but I hope you have enough information in this to get it right on the first print. Please note that the Floki on the design is there to press against the back of the phone to help lock it in and not just a vanity thing but my go pro battery box was being sold on eBay and I never branded that so I though hey why not. I want to share anything I design. If you have a 3Dconnexion mouse wireless then I highly recommend my case for that.