Tripple Magsafe Stand

This is a remix of the Magsafe stand that remixed by Lenrui.
51
251
2
2563
updated March 23, 2023

Description

PDF

This is a remix of the 3 in 1 Magsafe charger that was remixed by Lenrui.  This model has a much larger area for the cable of the lower Magsafe charger.  It also has a little larger channel for the lower charger cable to allow for it to be pushed into place. 

I only have the .3mf file for use with PrusaSlicer because I made the changes to the model using the modifiers within the slicer.  This may not work using a different slicer.  I recommend printing as it shows, on it's side, and to use the Organic supports that are currently in the 2.6 alpha version of PrusaSlicer.   

You may also notice that the upper charger in my photos is not an official Apple Magsafe charger, rest assured, the official charger will fit. I also used a little bit of two sided tape to help secure the larger chargers into place.  They have a snug fit, but my Rokform phone case also has a magnet on it and it can pull out the chargers from the stand.  You may find that you don't need the double-sided tape. 

This is an awesome stand and it's been modified a few times between Printables and Thingiverse.  

Side Note:  Adding some double-sided tape to the bottom of the stand will make it easier to pull your phone off from the charger using a single hand.

Tags



Model origin

The author remixed this model.

License