Logitech MX Mechanical under desk mount

This is my attempt to mount the logitech MX Mechanical under my desk when not in use. 

When designing I had two goals in mind:

• The feet can stay unfolded when placing in the holder. 
• No useless material wasted
• Not scratching the keycaps when mounting

For these reasons the holders are quiete small and use less then 25g of filament each. 
For the MX Mechanical with numpad I mounted these 32cm apart (inner side of table mounted plate).

Printed with (basically) 100% infill as so thin. 

Due to the back sides of the holder one left and right holder needs to be printed. They are simply screwed in the table using two countersunk screws (4mm) on each holder. If you don't want to use screws you can also use doublesided tape.

V4.1: I added some spots so the keyboard can not be pressed against the table which would end in unwanted keypresses. The holes are still the same, so you can reprint it and use the old holes.

I hope you like it! :)