I couldn't find any temp tower fitting my needs, so I made one myself, with a variety of tests:
Different overhang angles ( 50° ,60° ,70°)
bridging (quite common)
Stringing
Thin pillars (2 mm)
Brittle test pike, you break it with your finger to find the most fitting layer bonding
Single wall route
Overhangs of different lengths (60 mm,50 mm, 40 mm)
Square and round hole 3 mm.
I hope somebody else will find it anyhow helpful.
You can tweak the layer height since printing overhangs over 60° shouldn't be possible with 0.2 mm layers and 0.4 nozzle.
Changing the temperature needs to be done manually inside slicer on the height meter insert the G-code (by right mouse button)
“M104 S215” - for temperature 215°C
Updated version 2
has multiple different pillars (1 mm, 2 mm with 1 mm hole, 3 mm, 0,5 mm and 1,5 mm)
square and round hole are removed
text is more readable
brittle peak is more accessible
parts are bit more spaced out (by 2 mm) so bridging doesn't lie on single wall extrusion
The author marked this model as their own original creation.