Logitech standalone USB shifter and Pedals

This is a project box out house a Pro Micro knockoff board and two DB9 plugs to use for Logitech foot pedals and shifters as a standalone USB controller without the need for the Logitech Wheel base. Use your Logitech Pedals with a wheel of your choice.

This was created for this github project https://github.com/n-e-y-s/G27_Pedals_and_Shifter/tree/n-e-y-s_devel

Print with no supports, flat sides down. .20 or .30 layer should work fine. Use a m3 screw to secure the top, or glue for tighter fit. I used m3 nylon screws and nuts to secure the db9 plugs.

I use cheap pro micro boards from Alliexpress that press fit into place. There is a slot next to the screw tower to lift up the board if you ever need to remove it again.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

200

Infill:

100

Filament: Overture PETG Post-Printing =============

1st revision photo, slight changes made since

1st revision photo, slight changes made since