OmniBox Lower Bay Short Tray for BTT U2C

OmniBox Lower Bay Short Tray for the BTT U2C
5
38
3
264
updated April 8, 2023

Description

PDF

This is a short lower bay tray for the OmniBox to mount a BTT U2C (USB to CAN) board. Intended to be used in the middle bays with the extended tab towards the rear.

Because of the green terminal block on the one end, you may find that you need to use BHCS instead of SHCS otherwise the 24v in may be slightly blocked.  Four M3x4 will hold the U2C in place very well.  Use four M3x6 to mount the tray to the OmniBox.

Choice of material shouldn't matter so PLA or PETG should be fine if the OmniBox will be on a desk and has good ventilation.  If it is where it gets hot or has poor ventilation, then ABS/ASA are recommended.

Designed to be printed with a 0.2mm layer height using a 0.4mm nozzle.  Use standard print settings for the tray.

For more information about the OmniBox, please visit https://www.printables.com/model/354643-omnibox or https://jon-harper.github.io/OmniBox/ (main docs for the project).

Tags



Model origin

The author marked this model as their own original creation.

License