Hex Table Lamp

Cool! I want to try another one with clear PETG windows or just thinner white ones. Good pressure fit on the snap-in, I didn't resize and they fit snugly

I really like the design of this lamp. Printed very nicely. I did reduce the scale of the hex pieces by 0.5%. I found they fit a bit too tight and were warping the panels. I used translucent purple PLA which transmits the light well. I couldn't find the LED light here in Canada so I printed a cylinder and wrapped it with an LED light strip with a dimmer switch.

good

I modified the base panel to also have a hex grid and allow a light to pass through it. My clear filament was too transparent to diffuse a lightbulb but a standard piece of paper did great! It is impossible to get a picture that shows the color, but with Hue light bulbs it really is something spectacular.

Perfect!

Made with the remix of @3DMorris to put a connected LED strip of 50cmTo solve my problem of assembling the hexagons, these were printed at 96%, so the assembly is very easy

I really like this lamp. Thank You for the model. It is gorgeous 👌. (edited)

Awesome lamp! Printed the orange panes at 98% otherwise the fit was to tight for me.
This is probably my printers fault and not the model!

Printed with Prusament Galaxy Black and Jungle Green PETG.

Great design ! Thanks for sharing.

Turned out pretty well. Had to slightly tweak the insert bits to fit as they were a tad too big.

Used the light in the design too.

All in all I think it's great 👍

My version of your work thanks a lot.