Simple design to help clear up space in my hobby room. Allows you to hang up your RC car and controller. I designed this to try and be as universal as possible but so far it works with an arma and axial scx10. The hooks are designed to be removed and adjusted as needed.
I recommend using a support blocker with Cura to increase the infill density on the hooks where the dovetail joint meets the square. You could just increase the density of the entire hooks but it seems unnecessary. I used a support density of 20% for the mount and hooks.
As usual, be careful when driving the screws in. If you go to tight it will crack the mount body because this is plastic as I'm sure your well aware of ; )
The mount requires supports for the dovetail and I used supports for the screw holes as well.
Updates will probably be coming in the future. Im new to 3D printing and design so any feedback/makes are appreciated : )
Update Note 1:
Added a vertical tip at the end of the hook to prevent the RC from sliding off.
The author marked this model as their own original creation.