What forces is this intended to handle; off-axis? Can it be disassembled? As a thought: if it needs to be disassembled, some small holes in the side of the outer piece (up from the contact area) OR in the end of the outer piece would allow prying inwards on the leaves.
@MrScott_945955 Its supposed to handle just rotational forces clockwise or counterclockwise. Also, it is not necessarily supposed to be removable, I designed it so that people could incorporate it into a 3d model that needed to rotate. I can add holes into the joint test if you want.
What forces is this intended to handle; off-axis?
Can it be disassembled?
As a thought: if it needs to be disassembled, some small holes in the side of the outer piece (up from the contact area) OR in the end of the outer piece would allow prying inwards on the leaves.
@MrScott_945955 Its supposed to handle just rotational forces clockwise or counterclockwise. Also, it is not necessarily supposed to be removable, I designed it so that people could incorporate it into a 3d model that needed to rotate. I can add holes into the joint test if you want.