Handlebar Mount for 3 key Keypad

I designed this to use a small keypad to steer in Wahoo RGT virtual cycling program

This adapter is designed to fit a 3 key keypad and allow it to fit handlebars or Bar Ends. There are two different bar diameter models as well as 2 different configurations, Edge Mount and Rear Mount.

It easily prints on a Prusa with no supports at a .3mm layer height

Use a pair of rubber bands or o-rings to secure the unit.

The adapters have a window to allow routing of the USB cable if needed

I am using a USB keypad rather than bluetooth to eliminate the need for batteries

This adapter is specifically designed for this unit:

https://www.amazon.com/dp/B08P1GY3GN?ref=ppx_yo2ov_dt_b_product_details&th=1

although with a bit of filing it may?? fit others?

The sliced file will make a total of 4 pairs of parts, each pair different as described above