Iphone 7 Case Pusheen

This is a Remix of the iPhone 7 Case by ScottyMakesStuff.
https://www.thingiverse.com/thing:2438585

Read the print setting and the post procesing before you get the files.

The Black on the pusheen silhouette is painted with a black marker but you can switch the color that you are using to print if you like.

To fit the phone inside the case, i recomend that you put the case over a flat surface, then fit the botton of the phone on the case, and then genlty fit the rest.

Print instructions

You have to set the perimeters to 4.
I made it in PLA and it works fine, but will be better if you dont use a material as rigid as the PLA.
Infill: 25%
Support: No

Inserting the Pusheen
In order to fit the pusheen inside the case hole, you have to sand a little the interior borders of the hole.

You dont have to glue the two parts together, because when you fit the phone on the case, it will keep it in place.