The best Bambulab Glass Top Led Raiser mod

i would like to know if it would work with the BLV riser?

Hi, is it someway compatible with the blv ams riser? Also, does it support 8m led strip as well or just 6mm? (edited)

Can I use any top glass riser, or does BL LED require this particular riser? I ask because some risers support a 45 degree angle for better directional lighting toward the center. Thank you!

I printed this in ABS. Now just need some LEDS to add the light,

Way better than the stock lighting

Printed in black PETG. Turned out very well and makes my printer shine.
Did a little mod on the BLE LED controller.

Came out great fits together perfectly

Curious what you created the .3mf file with. PrusaSlicer loads it fine, but Bambu Studio 1.8.2.56 complains and will only load the geometry. It's unclear if you have any special settings that warranted saving it as a project.

Hmm will PETG withstand the heat? Possible?

Printed with Bambu ABS, Red, with another in Bambu ABS Yellow printing in the background. Can't wait to get the LED's and controllers installed once they arrive. (edited)

Hello.. nice project.. but
Can you build a frame for indirect lighting?
Personally, I don't like seeing the LEDs as individual dots when I'm sitting. Doesn't look professional.
Maybe a white frame with a white cap or even better with a 45 degree edge.. then I would buy the module. (edited)

Wasn't able to print it without a brim due to the teensy tiny little wall on the inside of the female connector part/thingy...

On the P1S the glass top has a bit of play, note sure if the glass plate is just smaller on the P1S than on the X1.