Printed with PETG no PLA, small edges will brake with PLA!
Needed 2x M3 inserts D5.0 x L4.0. Insert those very carefully with an solder iron at 210 degrees recommended.
Needed 2x M3 screw as well ;)
Possibly the standard screws of an original DB9 housing to screw the housing to an RS232 port. See photo the orange printed connector.
Sanding is needed where the DB9 connecter will fit. It should fit easily, if not, the lips will break of when try to close the housing.
Space in the housing is limited, a tight soldering of wires on the connector is needed.
gd lck, gr Michel.
The author marked this model as their own original creation.