Don't let the lack of fingers and opposable thumbs deny your cat from all the fun.
Now your kitty has a fidget spinner all their own
Assembled model measures 82mm tall x 180mm wide (3.2” x 7.08”)
a 608 skate bearing is required - these can be purchased for as low as $4 for a pack of ten on Amazon or eBay.
a steel bearing is recommended, as they perform better than a 3D printed bearing, if you decide to print the bearing, I recommend using Ultimate 608 Bearing with Calibration Kit V2 by Matvey Kukuy
Print settings
To provide sufficient weight, 100% infill is recommended for the base and spheres , the remaining parts can be printed at 20%
supports are required for the spheres
printed parts:
additional items needed:
assembly:
Holes are sized roughly .6mm larger than the rods and threaded ends of the spinner to compensate for print anomalies - gluing is required
The author marked this model as their own original creation.