Dies ist eine druckbare Alternative zum Bauteil "Scoop" von Gravitrax. Anstelle von Kugeln als Gewicht werden Unterlagsscheiben verwendet.
Benötigtes Material:
Druckanweisungen:
Alle Bauteile mit Layerhöhe 0.15 mm und ohne Support gedruckt.
Bauanleitung:
Scoop3.stl: Entferne nach dem Druck die dünne Verbindung zwischen der Nut. (Diese wurde für bessere Druckbarkeit angefügt.) Schraube dieses Teil an Scoop2.stl mit Hilfe der 2.5M Senkkopfschraube. Achte auf die richtige Platzierung und Ausrichtung.
Scoop2.stl: Danach schraubst du an die anderen Enden des Bauteils je 5 Unterlagsscheiben mit einem Abstandhalter.stl dazwischen.
Mast.stl: Drucke dieses Bauteil 2x aus. Stecke den davor montierten Scoop2.stl zwischen die Masten und verbinde die beiden Teile mit dem Stift 1.2mm für bessere Stabilität. Die ganze Konstruktion steckst du nun in die Basis.stl
Auslöser.stl: Schraube die kleine M1.5 Schraube in das kleine Loch von unten. Setze den Auslöser in die Basis.stl und stecke den Stift mit Durchmesser 1mm durch das seitliche Loch, um den Auslöser zu befestigen. Fülle etwas Klebstoff in das Loch, um zu verhindern, dass der Stift herausrutscht.
Inset.stl: Nun leimst du noch das Inset.stl unten an die Basis.stl an. Korrekte Platzierung der Aussparung beachten!
-------------------------------
This is a printable alternative to the Gravitrax "Scoop" part. Washers are used instead of balls as the weight.
Required material:
Printing instructions:
All components printed with a layer height of 0.15 mm without support.
Building instructions:
Scoop3.stl: After printing, remove the thin connection between the groove. (This has been added for better printability.) Screw this part to Scoop2.stl using the 2.5M countersunk head screw. Pay attention to the correct placement and orientation.
Scoop2.stl: Then screw 5 washers each to the other ends of the component with a Abstandhalter.stl in between.
Mast.stl: Print out this component twice. Insert the previously mounted Scoop2.stl between the masts and connect the two parts with the 1.2mm pin for better stability. You now put the whole construction into the Basis.stl
Auslöser.stl: Screw the small M1.5 screw into the small hole from below. Place the trigger in the Basis.stl and insert the 1mm diameter pin through the side hole to attach the trigger. Put some glue in the hole to prevent the pin from slipping out.
Inset.stl: Now glue the Inset.stl to the Basis.stl below. Pay attention to the correct placement of the recess!
The author marked this model as their own original creation.