Ender 3 V2 Neo/S1/CR Luminiz undercabinet light mount

This is a bracket to mount a 12" Luminiz T512124-F1WWC LED undercabinet light to a Creality Ender 3 V2 Neo.

This should also fit the 2020 extrusions on the Creality Ender 3 S1, S1 Plus, CR-M4, CR-6 SE, CR-10 and CR-6 MAX. On these extrusions for the horizontal section of the gantry, there is a channel in back but a stiffener panel in front with 4 small guide channels. This bracket locks into the back channel and slides along the small guide channels on the front. I printed two and slid them down the channel from one end. Then I spread/twisted the light holder section out slightly to get the light in.

It holds the light VERY securely yet is just loose enough to adjust a little in place.

Printed with:

0.20 layer height (0.28 should work as well)

50% infill (this is a structural part and should be strong)

Printed in PLA+. PLA should work as well, it doesn't need to be spread out that much to accommodate the light.

The Luminiz T512124-F1WWC has been discontinued. Newer models like the T5101013CTWH should have similar overall dimensions since they all approximate an old T5 fluorescent light. Since this bracket clips over the whole light extrusion and not the small channels, it should still work.