IMPROVED Raspberry Pi Camera Mount - Waveshare - RPi Camera (B) - OV5647 - 40mm

So I am new to Fusion360 and made an improved version of my Raspberry Pi Camera mount!
This Camera specifically is;
Waveshare - RPi Camera (B) - OV5647

This mount uses two 40mm fan spacing screw points.
I made this to match the 40mm fan case design for my Raspberry Pi 3 from here;
Malolo's screw-less / snap fit Raspberry Pi 3 Model B+ Case & Stands by Malolo | Download free STL model | Printables.com
(Black case = Malolo's Screw-less / snap fit case - H20 Fan40)

You can find V1 of my Camera mount - V1 Camera Mount

V2 Improvements;
More rounded and refined, cable routing, centered main neck, longer neck and better spacing for the use of nuts.

The Camera slides into the main piece and then the attachment piece is pushed on and locks on, if it doesn't lock well then you might be able to use some screws to tighten it.
You may need to sand a bit if you have issues.

The mentioned attachment piece can use screws and the hinges use screws with nuts.
I purchased and used the following from ThePiHut in the UK;
“Nylon Slotted Cheese Head Screws - M2.5 x 20mm (10 Pack)” - (two on the hinges)
“Nylon Nut - M2.5 (10 Pack)” - (I used Two)

I printed on a Creality Ender 3 with 0.4mm Nozzle at 0.2mm and Tree supports at 20% Density where needed.
Sand if you need to.

Mouse Pad is The Duel by InfinityMice.

Feel free to use as long as you attribute/mention me!