My da vinci mini w makes good prints, but I wanted to get better results on bridges and overhangs.
3
34
0
528
updated September 12, 2020

Description

PDF

My da vinci mini w makes good prints, but I wanted to get better results on bridges and overhangs. That's how I constructed an object cooler.

50mm radial fan
https://www.amazon.de/dp/B071R9CQKH/ref=cm\_sw\_em\_r\_mt\_dp\_U\_ekPfCbC7TAWG0

see screenshots for print settings, also the part print direction you can see there

I make a little cut out in the printer case to prevent collisions. In the photos I tried to document the disassembly. I hope it is halfway to understand ;-)

Print instructions

Category: 3D Printer Accessories Summary

My da vinci mini w makes good prints, but I wanted to get better results on bridges and overhangs. That's how I constructed an object cooler.

50mm radial fan
https://www.amazon.de/dp/B071R9CQKH/ref=cm\_sw\_em\_r\_mt\_dp\_U\_ekPfCbC7TAWG0

see screenshots for print settings, also the part print direction you can see there

I make a little cut out in the printer case to prevent collisions. In the photos I tried to document the disassembly. I hope it is halfway to understand ;-)

Print Settings

Printer Brand: XYZprinting

Printer: da Vinci mini w

Rafts: Doesn't Matter

Supports: No

Resolution: 0.2

Infill: 30

Notes:

I print without support and raft, but I heated up my printbed with 2x10W resistors screwed under the alu plate left and right.

look there in the comments
https://www.thingiverse.com/thing:3490226/comments

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License