Pokemon mini trash bin Pokeball

Easy print for beginners, at least if you are familar with supports.

• print lower half and button with white filament
• print ring in black
• print upper half and flap in red

The item on the photo is printed with a 120% resizing to have it bigger. Resizing works in a large range, so maybe you replace your kitchens wastebin :-D

Original size (12cm diameter) requires 110 g filament, 120% enlarged size requires 190g.

Regarding supports:

• Lower half can use a little support for the bottom two centimeters, but it works without, too
• button should be printed in standing upright position with normal support
• ring needs normal supports
• upper half needs tree supports
• flap should be printed in standing position with tree support, see picture
  
   

Glue ring to lower half and glue button to ring. No screws needed. Maybe its useful to glue the upper halft to the ring, too.

Mounting the flap to the upper half is obvious, just bend the upper half a bit.