Y_Rod Holder Customised

Customized Y Rod holder for the MK3s+ Enables for easy Removal and installation of rods and bed for simplified installation or repairs.

The G-code says mmu2s but it is a singe extruder and extruder 1 so it should still work without the mmu2.

I put a pause in this slice so if you have issues with bridging you can put your square nut on and finish printing. You may need to put a little glue or something on it to hold it since mine just fell off. I would try the bridging first but if you need it the pause it there or slice yourself with the provided model file.

the Prusa part was 2mm thick on the bottom. For some reason my printer printed to thick for the front. I have since re-submitted files so that it is only 1.5mm from rod to base to ensure there is room to get the bolts in. The height is same as the the Prusa I bought premade and should therefore work fine for clearance. Since I have this part installed all files should be final.. thanks for your interest. So the nuts slide out really easy so I'm adjusting the design to accommodate. 

After Installing the bed I found some rubbing. Im sure It will Work fine But Im perfecting it. The new upgraded versions have a higher rod .5mm and are wider at the bolt holes 0.2mm. One version is with a Hex Nut and the other has the same Flat Nut with a snap to help hold the nut in for easier install. Im Printing Both now for testing. Thanks for your patience. Improved model work great see pictures.