Gardena garden hose holder

My Support for the garden hose did break so I was looking for a replacement part. Then I was thinking; I could make my own and place the cartridge closer to the wall so the forces to the support will be smaller.

The support is made for bolts with size of 5mm on a washer, 2 in total.
I have made the hole for the aluminium rod ø 25mm and a spacer to make it possible for multiple sizes. The spacer is for a aluminium rod with diameter 20mm.
If needed I can make other diameters on request.

Inside of the Support I have created modifiers with higher infill like 80% and on places where little to none forces apply I have set infill to 10%
So best is to use the .3mf file

Print instructions

Category: Replacement Parts Summary

My Support for the garden hose did break so I was looking for a replacement part. Then I was thinking; I could make my own and place the cartridge closer to the wall so the forces to the support will be smaller.

The support is made for bolts with size of 5mm on a washer, 2 in total.
i have made the hole for the aluminium rod ø 25mm and a spacer to make it possible for multiple sizes. The spacer is for a aluminium rod with diameter 20mm.
If needed I can make other diameters on request.

Inside of the Support I have created modifiers with higher infill like 80% and on places where little to none forces apply I have set infill to 10%
So best is to use the .3mf file

Print Settings

Printer: Prusa i3 MK3S
Rafts: No
Supports: none
Resolution: 0.2
Infill: 10%/80%
Notes:
Material: Prusament PETG white