SUPPORT MATERIAL TEST

!!READ ALL!!

with this print you can find out the maximum angle your printer can make without using supports! This could make you save filament and time. 
You can also test minimum radius and chamfer your printer can make.

HOW TO PRINT IT: 

• Place the side with lettering on the bed
• use your usual printing settings
• disable support
• infill 5-10%

HOW TO READ IT:

the curved side increase its inclination with every step on the other side, first step is vertical (90°) the others are the following:    85° 75° 65° 55° 45° 35°.

the radius dimension increases of 1mm every step: 1mm 2mm 3mm 4mm 5mm 6mm
chamfer dimension decreases of 1mm every step: 5mm 4mm 3mm 2mm 1mm  

Once the print is done is up to you to decide the maximum inclination without support, then go on your slicers settings and modify parameters 

TIPS & MORE

Try to print it with different layer height and speeds
Updates and similar test will arrive