TTGO T-Display ESP32 stand with battery case

Little stand for the TTGO esp32 board with the little lcd display. Fits a 504045 lipo battery inside. If you make it sleep, the battery will last several months (this board uses 0.3 mA on sleep). The USB-C and reset are available thru the case. No need for glue or anything, everything just fits snuggly.

NOTE: If your battery has a JST 1.25 connector already, check the polarity carefully with the cable included in the TTGO board.

Parts

*TTGO ESP32 T-DISPLAY: https://s.click.aliexpress.com/e/_ADirut *Battery: https://s.click.aliexpress.com/e/_AonIrT

Software options

• Flight radar: https://github.com/rzeldent/esp32-flightradar24-ttgo
• Clock: https://github.com/kd8bxp/Cheerlights_Clock

Print Settings

Printer:

prusa i3

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

50

Filament:

eSun PLA

Notes:

For the buttons you have 2 options, one is flat (button_on.stl) and the other one is rounded and easier to press. Just place the buttons in position and slide the board inside, match the USB-C port.

The cover.stl should held everything in place if you close it properly. Add padding if your battery is smaller than the recommended one.

Category: Electronics