A cool Parachute Holder for an Egg or any other Object.
Pro TIP: only use a egg if youre sure that it wont get completely destroyed, remember it is still bio-material (food etc.).
I remember i used to build something similar to this in the 3th school grade :)
assembly
Just use strings and loop them through the 4 Holes on the 3d-printed Holder/container and tie them to a Plastic or Paper Bag (i recommend paper as its better for the environment :^) ).
Then the next step is to just have FUN
launch it by dropping it from any height to see how it falls or glides to the ground. If you picked a good bag the egg wont even get a scratch
Have Fun and enjoy being outside
-Dangel :)
Creality Ender 3 MAX:
-Print Time: 2h 15min
-Layer height: 0.16mm
-Infill: 12%
-Material: 13g/4.41m
The author marked this model as their own original creation.