Hela Figure for display.
Idk what you would normally call it but edited 2 models into one and tied it to repair the models where there are no holes and should print without any issues.
I am new at this and trying things out.
The 2 models I used were from
(Hela Miniature)(base and crown): https://www.thingiverse.com/thing:4173111
(Hela - MUA3) (body): https://skfb.ly/6Zy8S
You should be able to split the model up in Meshmixer to print them one by one.
I mean, print it as you would normally print your action figures.
I use too many different settings for different parts I don't even remember.
You can try to print the thing in one piece (Not recommended).
Try to cut Parts up as you feel comfortable.
I had to make holes with my small screw diver in the body and arm .2mm +screw driver
by heating it up with a candle and making a hold in the arm and putting the filament sting in it and trying to join them that way.
This Project was a Gift to a close friend.
Will upload the Picture when I am done sticking the parts.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.16
Infill:
20
Filament: any PLA and PLA+ White
Notes:
I mean, print it as you would normally print your action figures.
I use too many different settings for different parts I don't even remember.
You can try to print the thing in one piece (Not recommended).
Try to cut Parts up as you feel comfortable.
I had to make holes with my small screw diver in the body and arm .2mm +screw driver
by heating it up with a candle and making a hold in the arm and putting the filament sting in it and trying to join them that way.
The author remixed this model. Imported from Thingiverse.