These are router templates for creating the necessary indentations to flush mount sewing table hinges.
There are two versions:
You need both elements of either version. Hold them down to the table with double sided tape. The necessary depths for my hinge models were 2 and 6.5 and that's why you find those values on the models. This might be different regarding your hinges, so take some decent measurements.
If you have a very heavy and big router, use the bigger ones ;-) - I used the Makita/Katsu trimmer at first and it was totally fine to use the smaller ones.
And... I did not print the hinge, the STL is only for reference...
Printer Brand:
Anycubic
Printer:
Kossel
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15
Filament: unknown PLA
Category: DIYThe author marked this model as their own original creation. Imported from Thingiverse.