This is a holder for the small Dell USB-C mobile dock. It is really handy, but its connector cable is too short if you want to put your laptop on a stand. Without this holder it puts a lot of stress to the USB-C connector. The holder mainly acts as a strain relief for this short cable.
The distance between the mounting holes is 30mm.
The laptop stand used in my case is the "Millenium Laptopstand" by Thomann: https://www.thomann.de/de/millenium_laptopstand.htm
I recommend M5 screws and nuts to screw it onto the stand. And I also recommend one of these little, beautiful things to make your life a little bit easier: https://www.thingiverse.com/thing:5532943
Printer Brand:
Anycubic
Printer:
Kossel
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
15
Filament: DasFilament PETG bordeaux
Notes:
Print the round part straight on the plate, but lay the angled part on the side and print with support from build plate.
Post-Printing =============It is designed to fit together without any glue or so. If it is too tight, when you put the two parts together, simply take little bit of sandpaper and rework the long arm on the angled part until it is a snug fit.
Made with Fusion 360
Category: ComputerThe author marked this model as their own original creation. Imported from Thingiverse.