Another Bambulab filament guide arm

I'm using the awesome spool holder by Spam Filter

Unfortunately, the way the extruded filament gets pulled causes the filament spool to tilt towards the toolhead. This is a nuisance that can lead to the spools jerking off the holder, especially those pesky 250gr spools. The base screws into the original P1P/X1C filament guide holes behind.

Print with PLA/PETG at 40% infill and 3 perimeters for extra strength.

Use 2x M3x6 screws for the base and a single M3x20 for the hinge.