Prusa MK3s Bondtech Tri-Fan Mount

Result of some exploration around improving print quality via high volume but slow(er) airflow.
9
30
0
907
updated August 31, 2020

Description

PDF

Result of some exploration around improving print quality via high volume but slow(er) airflow.

Rear fan mount collides with frame, so the Z-axis mount needs to be replaced. Z_MAX_POS also needs to be reduced via firmware modifications or else Z calibration will fail.

Slightly longer M3 screws are needed for the rear fan mount, and two 10mm M2.5 screws are required for assembly of the fan arms for the non-Volcano version.

Design files can be found in the original blog post at
https://0x7d.com/2019/prusa-360-cooling-shroud/

Print instructions

Design files assumes a well calibrated printer.

Fan ducts are printed in vase mode with 1mm extrusion width using a 0.4mm nozzle. You may need to tweak the extrusion width a bit to get a good friction fit.

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License