Soldering tool with clamp mechanism

Going to come in very handy. Thanks for the share!

Ignored the instructions to print with PETG, it's a bit stiff with PLA but holds the cables firmly :)

Pretty stable and works well. THX!

Very useful, thanks for sharing!

Broken After a few uses

Great mode. ive been making up a cable for my Accelerometer on my printer and didnt have any roll left so i soldered a load together using this.

Thank you very much, clever idea. Unfortunately with PETG id didn't work to well for me: The clamp is not closing any more after it was used 5-10x. Still very appreciated that you shared the model :)

This is the best soldering clamp tool I tried so far.
Thanks for sharing.

Printed on the XL with Input Shaping and 0.4mm nozzle.

Print Settings: 0.20mm Speed with the following modifications
Perimeters: 3
Infill Pattern: Gyroid

Easy and works well though I may have pressed to hard on one side. Still works ok with the pressure

good model a print ok thx to share