Drag Knife for MPCNC universal mount

I've remixed the original drag knife from onasiis, adapting for the universal mount of the MPCNC.
14
79
2
680
updated February 12, 2023

Description

PDF

Update 2016-12-03: increased space for universam mount.

I've remixed the original drag knife from onasiis, adapting for the universal mount of the MPCNC.

You will need:

  • 2x 608Z bearings
  • 2x M3 scews for the blade holder
  • 4x M4 screws and nuts for the 2 part of the body

The round shaft should fit the inside of the bearings tight. You need to sand the shaft until you are able to insert the shaft in the bearings. You will need to apply a force to insert the shaft in the bearings, do not sand the shaft too much, otherwise the part that holds the blade will fall out from the bearings.

The M3 screws do not need nuts, they will fit the hole in the rotor part. I've also increased the space between the two holes, thus you can leave tighten the left screw and untighten only the right screw when you need to remove the blade.

Please note that the uploaded file are slightly different from the printed one in the pictures. I've made little improvements, but I didn't print them again. If you find something wrong, let me know.

I plan to design a blade cover in order to be on the safe side when I have time.

Print Settings

Printer:

Prusa P3Steel

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

60%

Category: 3D Printer Parts

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License