Glock Rear Sight Blank

This fills in the rear sight dovetail on Gen 5 MOS Glocks. I run full-size RDO on my full-size Glocks and I do not utilize a cowitness for competition shooting. I find the stock rear sight white box to be distracting in this configuration, so I remove both front and rear to (however minutely) reduce the slide weight. I couldn't stand the empty spot on the slide, so this is a result of that. Also adds a little pop of color if you don't stay with black.

Printer: Ender 3 S1 on PEI bed

Material: E-Sun Orange PLA+

Resolution: 0.12

NozzleTemp: 200

Bedtemp:60

Infill: 100%

Time: about 4 minutes

You may need to sand a little (I didn't) but the fit was TIGHT and I did mar up one end / have to do cleanup as a result. Next time around, will sand slightly to better the insertion fitment.