This allows you to line up your collection of Korg Volca synthesizers nice and neatly in a drawer or on a work surface. The Volca itself will easily slide in and out of the holders, but provide enough support that they're unlikely to topple over. They fit neatly into the deeper of the Ikea Alex drawers meaning you can keep them out of the way but easy to grab when you need.
Tested with Keys (see note below), FM and Sample v1. I don't have others to test.
This comes in two parts, A & B. You will need to print one of each and place them on the grid opposite each other with 3 squares of gap between them (see photos). Making this into one single unit would have been a waste of filament and would not have fit on to the Prusa MINI.
The volca is held on the grid off-centre to allow room for the controls on the front. You can use different orientations between the holders to allow more or less room as you need - just experiment until you have an orientation you are happy with.
NOTE - The Volca Keys has a particularly large pair of knobs (oo err) that make it difficult to fit alongside other Volcas in these holders. I just made sure to have the Keys at the far end of mine. so that it is unlikely to collide with other things
The author remixed this model.