YubiKey 5C NFC Case/Keychain (USB C only) with STEP file

Love it! Works without glue, but after glueing it, you get this satisfying click when closing or opening the case.

I probably need to use Brim next time for my printer😅 but design is great

I will use different colors to distinguish my Yubikeys.

The pressfit at the parts could be a bit tighter. But Glue solves that ;)

There's a small gap between the parts - otherwise it fits, looks and works just fine. Printed in Rosa3d PCTG

The small pieces printed perfectly. The large pieces were a struggle to put together. I may have to play with the print settings.

Would it be possible to get the models in STEP or F360 please? I want to remix for myself and put the keychain hole on the other side. Thank you in Advance! (edited)

There's a small gap between the two cap halves which annoys me, so I'll glue it (tough to make it snap in at that part, understandably). Otherwise, fits perfectly, great design !

I printed it in PLA, it's a good fit, although I get a small gap between two parts. Probably cause it's tested on PETG.