PTFE Cutter and 60° In and Out Tool

UK: 
PTFE Cutter and 60° In and Out Tool

With this PFTE Cutter you can easily make your 4mm PTFE tubes in both 44.3 mm and 50 mm.

At the same time, you can adapt the Tube tube at both ends External 60° / Internal 60° 
So filament can slide through without problem.

PTFE tube Use in Hotend for Prusa:
MK2.5S • MK3S • Mk3S+ • MMU2S • MK2/S • MK2.5 • MK3 • MMU2

Information see photo also:
Pinolbor/Centerbor see diagram photo
1 piece. Spindle screw M3 3mm
1 piece. M3 10mm
1 piece. M3 Nuts
1 piece. M3 6mm
1 piece. 9M Stanly Knife Blade

Print Information:
Filament:    Devil Design PETG
Hotend:       235
Pray:            85
Layer:          0.20mm Quality @MK3

Regards

Leif Lumby Henriksen
Odense3D Facebook “https://www.facebook.com/groups/2911561982402973”

DK: 
PTFE Cutter og 60° Ind og Udvendig Tool.

Med denne PFTE Cutter kan du nemt lave dine 4 mm PTFE rør i både 44,3 mm og 50 mm.

Samtidig kan du tilpasse røret i begge ender Ekstern 60° / Indvendig 60° Så filament kan glide igennem uden problemer.

Brug af PTFE-rør i Hotend til Prusa:
MK2.5S • MK3S • Mk3S+ • MMU2S • MK2/S • MK2.5 • MK3 • MMU2

Oplysninger se foto også:
Pinolbor/Centerbor se diagram foto
1 Stk. Pinolskrue M3 3mm
1 Stk. M3 10mm
1 Stk. M3 Nuts
1 stk. M3 6mm
1 Stk. 9M Stanly Knivsblad 

Udskriv oplysninger:
Filament:     Devil Design PETG
Hotend:        235
Bed:              85
Lag:              0,20 mm Kvalitet @MK3




Med venlig hilsen

Leif Lumby Henriksen
Odense3D Facebook “https://www.facebook.com/groups/2911561982402973”