xTool D1 Alignment for Honeycomb 400 x 400

I have a 400x400 honeycomb but could not find some feet to align it to my xTool D1.

So I designed them.

I made two versions.

Version 1 - It aligns the honeycomb centered.

Version 2 - It aligns the honeycomb a bit lower to the center.

This optimizes the working area a bit.

The holders also have some holes to put your pins in or to fix the holders to a plate.

I added a 2mm space between honeycomb and steel plate for better ventilation.

Printing these thingies is pretty easy. You can also dispense with infill what makes this print a bit faster.

In my experience you get the best print results if you print it upside down, to get a nice and clean surface to the 1mm steel baseplate.