KSGER T12 OLED controller soldering station case

I bought an KSGER controller and a 24V/75W power supply to make this DIY soldering station.

The PSU is a bit bit, probably I re-create the thing with a smaller PSU so the case can be made smaller (it can be made smaller with this PSU too, I just didn't want to print it again).

Print the main case upside down with support from printbed only. Other parts don't need support.

You need countersunk M3 screws to close the case and in addition to the controler/PSU you need a switch, a powerplug and a fuse holder.

OpenSCAD included, feel free to modify.

If you like this design, please post a rated make and give it a like! Thank you!