Thx!
Small Clip with Teeth
Easier printing, thanks to larger clearance, chamfers for optics, haptics and better printability.
70
706
11
1430
updated November 1, 2023
Makes
Comments
Nice little helpers for daily struggles.
Printed the original size and as well a smaller down scaled one.
@CLWM
Great pictures, thanks for your rating and make.
Made 3 at 100% scale in PLA but impossible to separate them ðŸ˜
Thank you for design and sharing!
Printed with PETG. Works good.
It was quite a challenge to print 10 of these at same time at 50% scale.
Apparently slicers starts to print faster and with lower fan speed as layer time become longer. So one clip printed fine but for 10 it causes teeth melting.
Increase minimal fan speed and lowering speed helps. (edited)
@baky126_1262751 Thank you too! :)
This is the best version of bag clip. Original one has no teeth and the remix I tried, well... it has teeth but they melt together during print. I used Cura to slice this one and in order to slice it right you need to enable "Print thin walls".
PLA+ (maybe a bit too wet)
I was not able to separate the teeth at 50% without breaking them, but at 75% it was possible. Not actually sure this is much better than the version without teeth, and it's a lot more trouble
@Philipp_900809 hey, sry that it works not perfect for you. Try to reduce the flow when printing so small.
At 100% this clip is not really small :)
Scale down with caution as the teeth will fuse together at some point.
@ls6_534717 hey, thanks for posting. Yeah it's not so "small" but as i wrote in the description i usually scale them down to 50%. That's the reason i increased the space between the teeth, added some fillet and posted this remix. Everything below 50% scale, did i not print :)
Funktioniert sehr gut, leicht zu drucken!
@LukasWolf thanks for posting your make and rating :) (edited)
@Buka_420178 thanks for posting your make :)