Mini Car!
This is a small and very fun car! Powered by an elastic band, it brings back childhood memories for the older ones and creates memories for the younger ones, suitable for people of all ages.
Print out the model and have fun assembling and playing with the car!
3D Printed Parts:
1 x Body
2 x Chassis Axle Guide
1 x Driver
1 x Front Axle
2 x Front Rim
1 x Rear Axle
2 x Rear Rim
4 x Tire
1 x Grid
All the parts are printed in STL orientation with a 0.4mm noozle, 0.2mm layer height and 15% infill.
Extra Parts:
8 x M3 10mm Bolts
2 x M3 Washers
12 x Mini Rubber Bands (Tires)
1 x Rubber Band
Assembly:
1 - After removing the supports the Grid must be placed on the Chassis.
2 - The Driver should be fixed on the Chassis with a screw.
3 - The Chassis Axle Guide should be placed on the Chassis.
4 - The axles should be placed on the Chassis and the Front Axle fixed with a screw.
5 - The Tires should be placed on the Rims.
6 - The wheels should be placed and fixed with the screws.
7 - You should add 3 mini elastic bands to each Tire.
8 - A screw should be placed in the Rear Axle.
9 - A screw with two washers should be placed in the remaining hole in the underside of the Chassis.
10 - The elastic band should be placed between the washers and the screw tightened (green circle).
11 - To move the car the elastic must be attached to the bolt protruding from the rear axle (blue circle) and you must turn the wheels to wrap the elastic around the axle.
12 - Place the car on the ground while holding the rear roses.
13 - Drop the rear wheels and get ready for fun!
The author marked this model as their own original creation.