NodeMCU ESP32 S2 with DHT11 Sensor Case

This is my rendition of a case with lid for the ESP32 S2 NodeMCU board to house the DHT11 temperature and humidity sensor. This model also have the Home Assistant logo embedded on the side. This simple design ensures a tight fit for the ESP32 S2 board, and also a squeezed fit for the DHT11 sensor. Also, enough space has been allowed to make use of Dupont cables inside the case. Small air-vents will also ensure the ESP32 S2 NodeMCU board stays as cool as possible to not have interference with the DHT11 sensor module. 

I make use of this design for all my ESP32 S2 boards with DHT11 sensors throughout my home. ESP32 Devkit V1 configured for use in Home Assistant using ESPhome.