Generic PETG Noz: 0.4 Layer: 0.2 Structural
15% infill, gyroid
No brim, No supports
Great design - thank you very much! I chose this case b/c I just have some work-horse PIs that needed a home.
I don't use addon disks - so I had to re-size the backplates down to about 30mm in height. Probably should have gone with 31mm to get a better fit but am happy with the results. Hexagon holes became hexatangles, but that's ok.
Suggestions:
1. Add a 1U backplate (hextangles are wrong)
2. A tray to hold 4010 fans horizontally over the pi for individual mobo cooling
3. Name plates? (node name & ip) (edited)
