Spice Rack

Simple Spice rack design.

I wanted to be able to have a spice rack that could be mounted to a cabinet door and still be removable. The Rail can be mounted using screws through the holes or there is a recess on the back to allow the use of double sided tape. If you want to use magnets the rail will not currently sit flush to the side of whatever you are sticking it to.

The Spice Rack slides on to the rail with one side essentially locking it on the rail securely.

Rack Dimensions

57.3mm x 50mm x 215.9mm or

2.25in x 2in x 8.5in

Rail Dimensions

6.5mm x 50mm x 215.9mm or

.25in x 2in x 8.5in

Print Settings

Printer:

Bambu Labs X-1 Carbon

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

.2mm

Infill:

25%

Filament:

Matte Grey

Notes:

I oriented the print with the bottom of the spice rack on my build plate and used hybrid supports on the rack only for the French Cleat overhang. On the rail I oriented it with the back down and used minimal supports for the recess.

So far I have only removed supports and deburred all the sharp edges.

You could definitely sand if you wanted to get rid of the layer lines. They are not that bad when looking from the front or side but are noticeable on the curved portion from the top.