raspberry pi and buck converter mount for Ender 3V2

A mount for a raspberry pi 4B and a buck converter to help transform your ender 3 v2 to use klipper.
10
34
0
535
updated January 25, 2023

Description

PDF

Trying to turn your slow ender 3 v2 into a klipper beast? Well you will need a place to put the raspberry pi and buck converter to run klipper off of. This is a simple mount and cover that replaces the drawer on the printer. Im not sure if it will fit on an original ender 3 but possibly. It has plenty of space to put a buck converter and a raspberry pi 4B next to each other with a wire slot in the back left for main power to the buck converter and a large opening in the front side left to access the usb and ethernet ports. The lid has an opening in the top that allows a ribbon cable and power cables if needed to a screen. 

You may need to use a little bit of supports for the opening to the usbs and Ethernet, other than that you should be fine.

The buck converter i used:

https://www.amazon.com/gp/product/B081N6WWJS/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

The only hardware needed is:

5: M5x8mm bolts (only 3 are actually needed to keep it sturdy)

5: M5 T/hammer nuts (only 3 are actually needed to keep it sturdy)

8: M3x6mm bolts for mounting the pi and converter

4: M3x8mm bolts for lid (could probably get away with 6mm but i used 8mm)

Tags



Model origin

The author marked this model as their own original creation.

License