Hanging Drift Clip - 1/10 Scale RWD Drift

This is a hanging drift clip for 1/10 RC drift tracks. 

Prints in 4 parts. 

1 upright - prints flat on the back with the feet pointing up.  No supports needed. 

1 crossbeam - prints on the side.  Supports required under each interlocking tooth.  Very minimal.   BARELY fits on the MK3S printbed.  Literally have to turn it slightly.  

1 foot - prints without supports on it's side.  

1 hanging drift target - use a LARGE brim inside and outside to keep it attached while it prints standing up.  

EDIT:  Added a “v2” version of each file.  

 - The clip itself has more support around the top loop.  My son dropped my original…and it broke.  

 - The crossbeam has been shortened on the backside, and lengthened on the overhang.  Less balanced, but more versatile depending on your usage.  

 - The upright and foot now have pre-created holes for mounting, if you need it.  

EDIT #2:   I have now also added a “Drift Hit Wall-Mount” alternative for tighter locations.   It simply screws straight to the wall.   

You can see this drift clip working on my YouTube channel: